Busulfan (busulfan)

Alkyl Sulfonates Intravenous Vial (ML)

Advertisement

Last reviewed · Source: First Databank (FDB) drug data

Overview

Busulfan, a bifunctional alkylating agent, is an antineoplastic agent.

USES: Busulfan is used as a pretreatment for patients who are undergoing stem cell transplant for chronic myelogenous leukemia (CML).

Generic name: busulfan
Pronunciation: (bue-SUL-fan)
Drug class: Alkyl Sulfonates
Therapeutic class: Antineoplastics

Reference product & biosimilars

No reference, biosimilar or interchangeable associated with this drug.

Today’s intelligence on Busulfan

Intelligence content is not available yet.

Indications

The following indications are listed for Busulfan:

  • Conditioning Prior To Allogeneic Hematopoietic Stem Cell Transplant

Also known as: Conditioning Followed By Allogeneic Hematopoietic Stem Cell Transplant, Conditioning Prior To Allo Hsct, Myeloablation Prior To Allogeneic Hematopoietic Stem Cell Transplant.

Dosing

The manufacturer suggests the use of therapeutic drug monitoring to adjust the dosage of IV busulfan in children following administration of the initial dose.

The busulfan AUC should be calculated based on blood samples collected at specified time points; actual sampling times should be recorded. When measuring serum busulfan concentrations with the initial dose of the drug, blood samples should be collected at 2 hours (the end of the infusion), 4 hours, and 6 hours (immediately prior to the next scheduled busulfan dose). For doses other than the first dose, blood samples should be collected prior to the infusion (baseline), and then at 2 hours (the end of the infusion), 4 hours, and 6 hours (immediately prior to the next scheduled busulfan dose). Calculations based on fewer samples than specified may result in inaccurate AUC determinations.

Special instructions for drug administration and blood sample collection should be followed to ensure accurate therapeutic drug monitoring. An administration set with minimal residual hold-up (priming) volume (1-3 mL) should be used for drug infusion to ensure accurate delivery of the entire prescribed dose and to ensure accurate collection of blood samples for the measurement of serum busulfan concentrations. The administration set tubing should be primed with drug solution to allow accurate documentation of the start time of the busulfan infusion. The blood sample should be collected from a peripheral IV line to avoid contamination with the infusing drug solution. If the blood sample is taken directly from the existing central venous catheter, it is important that the blood samplenot be collected while the drug is infusing to ensure that the end of the infusion sample is not contaminated with any residual drug. At the end of the infusion (2 hours), the administration tubing should be disconnected and the central venous catheter line should be flushed with 5 mL of normal saline prior to the collection of the blood sample from the central venous catheter port. The blood samples should be collected from a different port than that used for the busulfan infusion. The time required to flush the indwelling catheter line should not be included when recording the busulfan infusion stop time. The administration tubing should be discarded at the end of the 2-hour infusion.

Collection of the blood samples should be performed by collecting 1-3 mL of blood into heparinized (Na or Li heparin) Vacutainer(R) tubes. The blood samples should be placed on wet ice immediately after collection and should be centrifuged (at 4degreesC) within 1 hour. The plasma should be harvested into appropriate cryovial storage tubes and frozen immediately at -20degreesC. All plasma samples should be sent in a frozen state (i.e., on dry ice) to the assay laboratory for the determination of plasma busulfan concentrations.

Busulfan AUC following the initial dose may be calculated using the following equation where AUC0-6hr is estimated using the linear trapezoidal rule and AUCextrapolated is the ratio of the busulfan concentration at hour 6 and the terminal elimination rate constant, lambdaz. The terminal elimination rate constant must be calculated from the terminal elimination phase of the busulfan concentration versus time curve. A pre-dose busulfan concentration of zero is assumed and should be used in calculating the AUC.

When busulfan AUC for dose 1 has been calculated, the following formula may be used for the adjustment of subsequent busulfan doses to achieve the target busulfan AUC of 1125 mcM*minute:

For the determination of AUC following subsequent doses of IV busulfan, determination of steady-state busulfan AUC (AUC0-6hr) should be estimated from the trough, 2 hour, 4 hour, and 6 hour concentrations using the linear trapezoidal rule.

Drug interactions

Additive myelosuppression may occur with concomitant administration of busulfan with other myelosuppressive agents. In addition, additive pulmonary toxicity may occur when busulfan is administered in combination with other cytotoxic agents.

Contraindications

There is no enhanced messaging for this drug.

Adverse reactions

There is no enhanced messaging for this drug.

Precautions

No enhanced messaging available.

ICD codes

CodeTypeDescription
Conditioning prior to allogeneic hematopoietic stem cell transplant
30233U2ICD10PCSTransfusion of allogeneic related t-cell depleted hematopoietic stem cells into peripheral vein, percutaneous approach
30233U3ICD10PCSTransfusion of allogeneic unrelated t-cell depleted hematopoietic stem cells into peripheral vein, percutaneous approach
30233U4ICD10PCSTransfusion of allogeneic unspecified t-cell depleted hematopoietic stem cells into peripheral vein, percutaneous approach
30233Y2ICD10PCSTransfusion of allogeneic related hematopoietic stem cells into peripheral vein, percutaneous approach
30233Y3ICD10PCSTransfusion of allogeneic unrelated hematopoietic stem cells into peripheral vein, percutaneous approach
30233Y4ICD10PCSTransfusion of allogeneic unspecified hematopoietic stem cells into peripheral vein, percutaneous approach
30243U2ICD10PCSTransfusion of allogeneic related t-cell depleted hematopoietic stem cells into central vein, percutaneous approach
30243U3ICD10PCSTransfusion of allogeneic unrelated t-cell depleted hematopoietic stem cells into central vein, percutaneous approach
30243U4ICD10PCSTransfusion of allogeneic unspecified t-cell depleted hematopoietic stem cells into central vein, percutaneous approach
30243Y2ICD10PCSTransfusion of allogeneic related hematopoietic stem cells into central vein, percutaneous approach
30243Y3ICD10PCSTransfusion of allogeneic unrelated hematopoietic stem cells into central vein, percutaneous approach
30243Y4ICD10PCSTransfusion of allogeneic unspecified hematopoietic stem cells into central vein, percutaneous approach

ICD code information from First Databank (FDB).

Formulary status

Search health-plan coverage for this drug by ZIP code.

Enter a ZIP code to view available health plans.

Last reviewed · Source: First Databank (FDB) drug data